RadioFM 2.1.3 (Nextgen)

File

Line

Function

/inc/class_error.php

153

errorHandler->error

/global.php(961) : eval()'d code

errorHandler->error_callback

/global.php

961

eval

/printthread.php

require_once

File

Line

Function

/inc/class_error.php

153

errorHandler->error

/printthread.php(287) : eval()'d code

errorHandler->error_callback

/printthread.php

287

eval

/printthread.php

117

printthread_multipage

Code:

# For more options and information see

# http://rpf.io/configtxtreadme

# Some settings may impact device functionality. See link above for details



# uncomment if you get no picture on HDMI for a default "safe" mode

#hdmi_safe=1



# uncomment this if your display has a black border of unused pixels visible

# and your display can output without overscan

#disable_overscan=1



# uncomment the following to adjust overscan. Use positive numbers if console

# goes off screen, and negative if there is too much border

#overscan_left=16

#overscan_right=16

#overscan_top=16

#overscan_bottom=16



# uncomment to force a console size. By default it will be display's size minus

# overscan.

#framebuffer_width=1280

#framebuffer_height=720



# uncomment if hdmi display is not detected and composite is being output

#hdmi_force_hotplug=1



# uncomment to force a specific HDMI mode (this will force VGA)

#hdmi_group=1

#hdmi_mode=1



# uncomment to force a HDMI mode rather than DVI. This can make audio work in

# DMT (computer monitor) modes

#hdmi_drive=2



# uncomment to increase signal to HDMI, if you have interference, blanking, or

# no display

#config_hdmi_boost=4



# uncomment for composite PAL

#sdtv_mode=2



#uncomment to overclock the arm. 700 MHz is the default.

#arm_freq=800



# Uncomment some or all of these to enable the optional hardware interfaces

#dtparam=i2s=on



# Uncomment this to enable the lirc-rpi module

#dtoverlay=lirc-rpi



# Additional overlays and parameters are documented /boot/overlays/README



# Enable audio (loads snd_bcm2835)

dtparam=audio=on

gpu_mem=256

dtparam=i2c_arm=on

disable_splash=0

dtparam=spi=off

start_x=1

program_usb_boot_mode=1

Code:

sudo tar cfzv carpc.tar.gz --exclude="map1.bin" /home/pi/.kodi/addons /home/pi/.navit/ /usr/bin/carpc-controller /opt/carpc/ /home/pi/.config/lxsession/LXDE-pi/autostart /home/pi/Bilder/ /home/pi/touchscreen_axes_calib /usr/local/bin/kodi* /usr/local/share/kodi/  /usr/local/include/kodi /usr/local/share/doc/kodi /usr/local/lib/kodi /etc/profile /etc/rc.local /etc/navit/navit.xml /etc/default/gpsd /etc/X11/Xwrapper.config /etc/init.d/asplashscreen /home/pi/.kodi/userdata/advancedsettings.xml /home/pi/.kodi/userdata/guisettings.xml