Hifiberry DAC+ light in CarPi einbinden

File
Line
Function
/inc/class_error.php
153
errorHandler->error
/global.php(961) : eval()'d code
errorHandler->error_callback
/global.php
961
eval
/printthread.php
require_once
Code:
# For more options and information see

# http://www.raspberrypi.org/documentation/configuration/config-txt.md

# Some settings may impact device functionality. See link above for details



# uncomment if you get no picture on HDMI for a default "safe" mode

#hdmi_safe=1



# uncomment this if your display has a black border of unused pixels visible

# and your display can output without overscan

#disable_overscan=1



# uncomment the following to adjust overscan. Use positive numbers if console

# goes off screen, and negative if there is too much border

#overscan_left=25

#overscan_right=25

#overscan_top=25

#overscan_bottom=25



# uncomment to force a console size. By default it will be display's size minus

# overscan.

#framebuffer_width=1280

#framebuffer_height=720



# uncomment if hdmi display is not detected and composite is being output

#hdmi_force_hotplug=1



# uncomment to force a specific HDMI mode (this will force VGA)

#hdmi_group=1

#hdmi_mode=4



# uncomment to force a HDMI mode rather than DVI. This can make audio work in

# DMT (computer monitor) modes

#hdmi_drive=2



# uncomment to increase signal to HDMI, if you have interference, blanking, or

# no display

#config_hdmi_boost=4



# uncomment for composite PAL

#sdtv_mode=2



#uncomment to overclock the arm. 700 MHz is the default.

arm_freq=1000



# Uncomment some or all of these to enable the optional hardware interfaces

#dtparam=i2c_arm=on

#dtparam=i2s=on

#dtparam=spi=on



# Uncomment this to enable the lirc-rpi module

#dtoverlay=lirc-rpi



# Additional overlays and parameters are documented /boot/overlays/README



core_freq=500

sdram_freq=500

# uncomment to force a HDMI mode rather than DVI. This can make audio work in

# DMT (computer monitor) modes

#hdmi_drive=2



# uncomment to increase signal to HDMI, if you have interference, blanking, or

# no display

#config_hdmi_boost=4



# uncomment for composite PAL

#sdtv_mode=2



#uncomment to overclock the arm. 700 MHz is the default.

arm_freq=1000



# Uncomment some or all of these to enable the optional hardware interfaces

#dtparam=i2c_arm=on

#dtparam=i2s=on

#dtparam=spi=on



# Uncomment this to enable the lirc-rpi module

#dtoverlay=lirc-rpi



# Additional overlays and parameters are documented /boot/overlays/README



core_freq=500

sdram_freq=500

over_voltage=2

gpu_mem=256

dtparam=i2c_arm=on



#device_tree_param=i2c0=on,i2c1=on,spi=on



dtoverlay=hifiberry-dac



lcd_rotate=2