Pollin LS-7T eingeschränkte Funktion

[schwoof]

Zu deinen Fragen:

Ja, der Touch funktioniert vor der CarPi Installation
Ich habe sowohl vor, als auch nach der CarPi Installation kalibriert.


Output mit "0"

Input driver version is 1.0.1
Input device ID: bus 0x3 vendor 0xeef product 0x1 version 0x112
Input device name: "eGalax Inc. Touch"
Supported events:
Event type 0 (EV_SYN)
Event type 1 (EV_KEY)
Event code 272 (BTN_LEFT)
Event code 273 (BTN_RIGHT)
Event type 3 (EV_ABS)
Event code 0 (ABS_X)
Value 0
Min 42
Max 1981
Event code 1 (ABS_Y)
Value 0
Min 42
Max 1981
Event type 4 (EV_MSC)
Event code 4 (MSC_SCAN)
Properties:
Testing ... (interrupt to exit)
***********************************************
This device is grabbed by another process.
No events are available to evtest while the
other grab is active.
In most cases, this is caused by an X driver,
try VT-switching and re-run evtest again.
Run the following command to see processes with
an open fd on this device
"fuser -v /dev/input/event0"
***********************************************

Output mit "1"

Input driver version is 1.0.1
Input device ID: bus 0x3 vendor 0xeef product 0x1 version 0x112
Input device name: "eGalax Inc. Touch"
Supported events:
Event type 0 (EV_SYN)
Event type 1 (EV_KEY)
Event code 320 (BTN_TOOL_PEN)
Event code 330 (BTN_TOUCH)
Event type 3 (EV_ABS)
Event code 0 (ABS_X)
Value 1118
Min 0
Max 2047
Event code 1 (ABS_Y)
Value 1325
Min 0
Max 2047
Event type 4 (EV_MSC)
Event code 4 (MSC_SCAN)
Properties:
Testing ... (interrupt to exit)
***********************************************
This device is grabbed by another process.
No events are available to evtest while the
other grab is active.
In most cases, this is caused by an X driver,
try VT-switching and re-run evtest again.
Run the following command to see processes with
an open fd on this device
"fuser -v /dev/input/event1"
***********************************************